Usage: iwpriv wlan0/eth0 COMMAND OPTION1 [OPTION2] [...]

Commands ("iwpriv wlan0"):

SetDebug - sets debugging/logging level (see L_* #defines in include/acx100.h)
Default: 0x009b
"iwpriv wlan0 SetDebug 0x000b" (L_STD | L_INIT | L_ASSOC)

SetRates - sets 802.11 transfer rates, basic and operational rate set
Default: depending on iwconfig rate
"iwpriv wlan0 SetRates "1,2 1,2,5,11,36,54" (basic rates 1, 2Mbps, operational rate set 1,2,5,11,36,54Mbps)

ListRegDmain - lists the available regulatory domain settings in syslog
"iwpriv wlan0 ListRegDomain", "dmesg"

SetRegDomain - sets the value of the regulatory domain setting
Default: depending on card EEPROM data
"iwpriv wlan0 SetRegDomain 3", "dmesg"

GetRegDomain - returns the value of the current regulatory domain setting
"iwpriv wlan0 GetRegDomain", "dmesg"

SetScanMode - sets scan mode (0 == active, 1 == passive, 2 == background)
"iwpriv wlan0 SetScanMode 0", "dmesg"

SetScanDelay - sets time (in ms) to wait per channel on a scan

SetSPreamble - Activates the Short Preamble transfer for slightly faster
rates (0 == off, 1 == on, 2 == auto, depending on peer support)
Default: 2, auto
"iwpriv wlan0 SetSPreamble 1", "dmesg"

GetSPreamble - returns the Short Preamble transfer setting
"iwpriv wlan0 GetSPreamble", "dmesg"

SetAntenna, GetAntenna, SetRxAnt, SetTxAnt - experimental antenna command

SetPhyAmpBias - sets the bias (offset) level of the "external" radio amplifier
Default: firmware dependent
Range: 0 to 7
"iwpriv wlan0 SetPhyAmpBias 4", "dmesg"

GetPhyBusyCount - get the percentage that the medium has been found to be busy
"iwpriv wlan0 GetPhyBusyCount", "dmesg"

SetED - change Energy Detect threshold setting
Default: 0x70 == 112
"iwpriv wlan0 SetED 150", "dmesg"

SetCCA - change Channel Clear Assessment setting
Default: 0x0d == 13
"iwpriv wlan0 SetCCA 15", "dmesg"

SetLEDPower - change power LED setting (save power)
Default: on
"iwpriv wlan0 SetLEDPower 0", "dmesg"

monitor - activate Kismet monitor mode (Orinoco card type)
Default: off
"iwpriv wlan0 monitor 2 4"

Test - random test functionality

DbgSetMasks - sets internal activation masks (debugging only)

DbgGetIO - query card I/O registers

DbgSetIO - set card I/O registers

GetAcx111Info - get misc. ACX111 firmware status information
