The better install/configuration documents are available at:
http://pyaim-t.blathersource.org/

There's really not much to the install at the moment.  It's important
to make sure you have the following installed:

- Jabber ;D
- Python
- Twisted (www.twistedmatrix.com)
- Optional: nevow (http://www.nevow.org/) for web interface

Then, in the same directory as this INSTALL, copy config_example.xml to
config.xml and edit config.xml.  Change the jid to the Jabber ID you want
this transport to answer as.  Change mainServer to the IP address or DNS
name of your Jabber server.  Change secret to the shared secret between
transports and your Jabber server (should be in router.xml for Jabberd2).
Change port to the port this transport is to connect to (also found in
router.xml for Jabberd2).  Edit other options at your leisure, they are
fairly self-documented.

If you are migrating from the C-based aim-transport, you can copy over your
spool directory into the same directory that this INSTALL file is.  (make
the jid field is set to the same name as this spool directory)  If you are
starting a fresh spool directory, simply mkdir the same name you used
in the jid field.  Note that you can set the actual location of the spool
directory if you want, instead of having to put it in this directory.

With Jabberd2, there's little else you need to do than run PyAIMt in this
directory.  It's important to know that you should -not- have an alias
line in your router.xml for PyAIM-t.

Note: the following instructions are provided almost word for word from
James Bunton, just modified for AIM.  ;)

With Jabberd1, you need to add something like the following to jabber.xml:
<service id="aim.host.com">
	<host>aim.host.com</host>
	<accept>
		<ip>127.0.0.1</ip>
		<port>XXXX</port>
		<secret>secret</secret>
	</accept>
</service>

Check that aim.host.com is the same as the 'jid' setting from config.xml
and that XXXX is the same as the 'port' setting. Also 'secret' must
correspond, and the 'mainServer' setting should be pointing to the same
interface as the <ip/> tag is (in this example the loopback interface is
used. So 'mainServer' would be '127.0.0.1').

You must also add this to the browse section of your jabber.xml file

<service type="aim" jid="aim.host.com" name="AIM Transport">
	<ns>jabber:iq:register</ns>
</service>

Once again, aim.host.com must correspond to the 'jid' setting in config.xml

Once you have made all these changes, restart your Jabberd1.4.x server,
then start PyAIMt and it should all work.

I'll have better instructions and such at some point when we're further
along.
