## Path:		System/Powermanagement/Thermal
## Default		"no"
## Type:		yesno
#
# Force polling of temperature to check for temperature state changes instead of 
# waiting for events from /proc/acpi/event
# 
THERMAL_FORCE_POLLING="no"

## Path:		System/Powermanagement/Thermal
## Default		"2"
## Type:		integer(0:50)
#
# This is used as a negative hysteresis limit for cooling limits
# to not switch too often (e.g. passive limit is 60, hysteresis is 5
# machine will be in passive mode at 60 and go back to active at 55 
# (all in degree Celcius)) 
THERMAL_HYSTERESIS="2"

## Path:		System/Powermanagement/Thermal
## Default		"15"
## Type:		integer(1:10000)
#
# Sets the polling intervall the temperature is checked.
# This depends on the CPU freq polling intervall (currently located in /etc/powersave.conf)
# A value of 60 and CPU freq polling intervall set to 333 (ms) is calculated to 20 seconds
# polling (15 * 333 (ms) = 5 seconds)
THERMAL_POLLING_MULTIPLICATOR="15"


# FOR SCHEMES:

## Path:		System/Powermanagement/Thermal
## Default		"dynamic"
## Type:                list(dynamic,fixed,off)
#
# This sets the policy how the processor gets throttled if the passive
# temperature limit is exceeded
# fixed: always use MAX_THROTTLING value while in passive mode
# dynamic: increase throttling if temperature still increases
# off: do not throttle at all (see README.thermal for more info)
THERMAL_PASSIVE_THROTTLING_POLICY="dynamic"

